| So far, the Satin gene has only been found in two hamster species: the Campbell's Dwarf and the Syrian hamster. The Satin gene in the Campbell's Dwarves is so different from the Satin gene in the Syrians that we’re going to deal with them in separate months. The Satin gene in the Campbell's is a recessive gene. There are no problematic breeding issues with the Satin Dwarves. Thus, you can breed two Satins together, and you will get all Satin babies. Alternatively, you can breed a Satin to a Satin carrier and will get approximately half Satin babies. There is not a specific point category for judging Satins. The effects of the Satin coat are typically seen in the Color and Markings (30 points) and in the Fur category (20 points). Color and Markings: As for existing varieties (e.g. normal, albino) allowing for satinisation. Fur: The fur should be soft, fine and have a glossy sheen. People sometimes ask me as a judge to explain which satin colors are standardized. For this, you refer to the standardized colors. Any color or pattern which is standardized will also be standardized with a Satin coat. Any color or pattern which is unstandardized will remain unstandardized in a Satin coat. Remember that all colors and patterns can be bred in a Satin coat. The Satin gene in the Dwarves creates a slightly longer coat which is lifted. This can sometimes make the coat appear less dense, so breeders of satins often find that coat density is one of the key criteria they use in their breeding selection. (Note the Argente Satin in the picture below. The fur right behind/below the ear is a bit thin. This fault is accentuated when the fur is lifted.) The Satin gene also gives a glossy shine to the coat which sometimes confuses people making them think that the hamster is wet or greasy. The BHA standard for Campbell's Satin does not offer a lot of help on the color portion of judging Satins. It essentially says that we judge the color of Satins the same as the regular standard with the needed allowances for satinization. Since the Satin gene affects the coat color quite a bit, breeders and judges need to educate themselves on how this gene affects the color. Below is a picture comparison of non-Satin to Satin for the most common Campbell's colors. From top to bottom is Normal, Argente, and Opal with nonsatin on the left and Satin on the right. (Albinos are standardized and also found in satin, and their coat sometimes has a slight yellow tint due to the satin coat.) |